CHASSIS STRAIGHTENING WITH SWEDISH SYSTEM
The great advantage of our chassis straightening system for industrial vehicles and trucks consists in the possibility of pressing and pulling the vehicle chassis simultaneously, keeping the undamaged parts in place. The system allows us to be selective when carrying out the repair. , which zones we untap and which zones we keep.
Workshop with Bench for Chassis Straightening
Being the industrial vehicle in general a vehicle with a robust and resistant design, it is easier to apply the force more uniformly. By pressing/fracturing simultaneously, we eliminate the possibility of causing additional damage, such as dents in rails or warped tabs. In this way we achieve a more precise, technical and less invasive repair with the vehicle, giving a final result of higher quality and lower cost in time and money.
Cold or hot straightening system
The teams perform cold or hot straightening, depending on the degree of damage, type of material, etc. Having the heat trump card we can neutralize the internal tensions of the material/vehicle, it even allows us a greater degree of rectification in the damage to be repaired. Applying heat more effectively and controlled in induction heating. Without forgetting a fundamental point: by applying heat we continue to maintain the option of repairing and deciding on specific areas of the vehicle in order to intervene in the most efficient way possible.
We have bench for Josam chassis
This bench is used and recommended by the following manufacturers:
- Scania
-Volvo
- Mercedes
-Iveco
-man
-daph
-Renault
-Navistar
-fruehauf
-Samro
We have a laser measurement system to verify and guarantee the repair carried out on the vehicle frame. We have induction heating system.
